Treon Industrial Node 6

Introduction Treon products, from the Treon Gateway to Treon Industrial Nodes within a mesh network, can be addressed via device management (DM) commands. These DM commands can be used to acquire information from the products, to change their configuration and to update them.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

Introduction Before and after the deployment of a mesh network, it is important to test and troubleshoot common issues in deployment.  Testing the Network Before you install the physical devices at the deployment site, first perform a dry-run of the system to test if the network runs.

This article shows the default configuration of the Treon Industrial Node 6. Fig.: Treon Industrial Node 6 DM Model.  Timer Parameters Time ON/OFF Measurement Selection Timer 1 1h ON 0 Timer 2 6h ON 1 Timer 3 24h OFF 2 and 3 Status Interval 3h ON none  Measurement Parameters Measurement ID 0 1 2 3 Default Axis 3 3 3 x-axis All G-Range 4 4 4 4 4 Sample Amount 36864 36864 36864 68268 110592 Calculations 1 and 3 2 and 4 5 6 0  Calculation Parameters CalcID 1 2 3 4 5 6 Default Features v-RMS, v-PEAK, v-P2P, Clipping detect LOW FFT, Clipping detect a-RMS, a-PEAK, a-P2P, Kurtosis, Crest, Clipping detect HIGH FFT, Clipping detect Raw data Raw data FFT, aRMS, aPEAK Low cut-off 10 10 no filter no filter no filter High cut-off 1000 1333 no filter no filter no filter Decimation 9 0 1 Averages 0 9 0 Overlap % 0 0 0 Window Hanning Hanning Hanning Lines of resolution 1600 1600 2048 FFT format Variable Variable Auto (no variable)  Wakeup Parameters Default Feature Enable OFF Wake-up G-range 4G Wake-up threshold 8 Wake-up Action Delay 30s Wake-up Blank-time 900s Action measurement ON Action Indication OFF Action LED ON Measurements to be triggered 1  

Introduction For this installation method, the Treon Industrial Node is directly attached to the machine surface. This minimizes the vibration transmission route for best measurement quality. Manual alignment of the Industrial Node is not possible with this installation method.

Introduction Treon products, from the Treon Gateway to Treon Industrial Nodes, within a mesh network can be addressed via device management (DM) commands. These DM commands can be used to acquire information from the products, to change their configuration and to update them.

Introduction Working with large amounts of data, that occur when transmitting burst data from the nodes to the Treon Gateway, needs to be taken into account when planning and deploying a mesh network.

Introduction Working with large amounts of data, that occur when transmitting burst data from the nodes to the Treon Gateway, needs to be taken into account when planning and deploying a mesh network.