Introduction When mounting the Treon Industrial Node and Treon Industrial Node 6 to a monitored equipment, it is important to consider the location of the sensor and the contact between the sensor and the machine.
What’s in the box The sales box of the Treon Gateway and the Treon Gateway 2 contains the following:
Treon Gateway AC power adapter Documentation Here is a short video showing the unboxing of the Treon Condition Monitoring Starter Kit with a Treon Gateway in Protective Enclosure and Treon Industrial Nodes 6:
What’s in the box The sales box of the Treon Gateway in Protective Enclosure contains the following:
Treon Gateway in Protective Enclosure Documentation Here is a video showing the unboxing of the Treon Condition Monitoring Starter Kit with a Treon Gateway In Protected Enclosure and Treon Industrial Nodes 6:
Introduction For this installation method, the Treon Industrial Node is directly attached to the machine surface. This minimizes the vibration transmission route for best measurement quality. Manual alignment of the Industrial Node is not possible with this installation method.
Introduction Using the Treon Magnetic Mount Adapter enables attaching Treon Industrial Node to uneven surfaces and without any opening for a bolt. The Treon Industrial Node will be pre-fixed by a magnet and the final installation must then be done with a suitable glue.
Introduction Using the Glue Mount Adapter enables attaching the Industrial Node to a flat surface with glue. It is possible to manually align the Industrial Node.
Installation with a Glue Mount Adapter requires a Treon Glue Mount Adapter, suitable glue, and a surface of 32 mm diameter.
Introduction It is possible to install your Treon Industrial Node and Industrial Node 6 either with or without epoxy.
Option A: Nut adapter installation with epoxy:
Minimum thread length can be less than 9 mm depending on the amount of epoxy Node alignment can be done manually